University of Tennessee at Chattanooga
  Engineering Laboratories on the Web
Developed with and using LabVIEW and NI-PCI DAQ from 
Clamped Proportional Feedback Pressure Station
Enter this Information about you:      
  E-mail address

Enter these Parameters for the Experiment:        
  Length of experiment (sec):

  Controller output bias value (%):
(=Baseline input value (%))

Controller tuning parameter and Set Point

 Proportional controller gain, Kc (%/cm-H2O):

Must be negative!

 Set-point value (cm-H2O):

Lab Wizard
Controller Output Clamping Specifications
  Floor (%):

  Ceiling (%):

Enter this Configuration Information:


Dampers #1 & #2
#1 -- closed (sec): for (sec) then
#1 -- open sec, then closed again (and repeating)
#2 -- closed (sec):
#2 -- open sec, then closed again (and repeating)


Copyright 1996-2011 Jim Henry
Last updated 20 February 2002
Feedback welcome & invited to
Send E-Mail to Lab-Master