University of Tennessee at Chattanooga
  Engineering Laboratories on the Web
Developed with and using LabVIEW and NI-PCI DAQ from 
  Proportional Feedback Pressure Station
Enter this Information about you:      
  Name
  Location
  E-mail address

     
Enter these Parameters for the Experiment:        
  Length of experiment (sec):

  Controller output bias value (%):
(=Baseline input value (%))

Controller Tuning Parameters
  Proportional controller gain, Kc (%/unit):

Set-point specifications
  Initial set-point value (cm-H20):

  Change of set-point value (cm-H20):

  Time of change of set-point (sec):

     
Enter this Configuration Information:        
Dampers #1 & #2
#1 -- closed  for (sec) then
#1 -- open for   (sec) then
closed again (and repeating)
#2 -- closed for (sec), then
#2 -- open (sec)
then
closed again (and repeating)
     
 
 


Copyright 1996-2011 Jim Henry
Last updated 6 April 2000
Feedback welcome & invited to
Send E-Mail to Lab-Master
> >